Quick Start Guide, XDS PRO4-P Receiver
Rev J - June 2, 2008
Page 4 of 11
o The default setting for DHCP is ON. Use the SET and arrow keys to change
DHCP from ON to OFF.
o Press the left or right arrow keys to go to the LAN Address menu. Press SET.
o Use the up and down arrow keys and the SET key to set the desired IP
address.
o Press the left or right arrow keys to go to the LAN Subnet menu. Press SET.
o Use the up and down arrow keys and the SET key to set the desired subnet
address.
o Press the left and right arrows to go to the Gateway menu and press SET.
o Use the up and down arrow keys and the SET key to set the desired gateway
address.
Assigning a Static IP address to the WAN Port:
If you elect to connect your receiver in a firewall zone called a “DMZ”
(demilitarized zone) or ‘“Outside” the firewall where it can see the internet
directly, connect your network cable to the receiver’s WAN port. You must
assign a static IP WAN Address, WAN Subnet, and Gateway. Follow the
“Assigning a Static IP address to a LAN Port” instructions above to go to the
appropriate WAN menus and change settings as desired.
NOTE: If your local area network (LAN) requires the use of a proxy server,
please refer to the online user’s guide located at your affiliate’s website. Refer to
Section 2 on page 7 of this document for instructions on how to login to you
your website.
B. Test connection to the NOC
o At the main screen with the network logo, press the SET key, then the left or
right arrow keys to reach Setup. Press SET.
o Press the left or right arrow keys to reach Network. Press SET.
o Press the left or right arrow keys to TEST NOC. Press SET.
o Press the NOC softkey to perform the test.
The test will take no more a minute or two. You will get a SUCCESFULLY
CONNECTED TO NOC message if your IP settings are correct. Otherwise you
will get a CANNOT CONNECT TO NOC message and you will need to adjust
your IP settings (on the receiver, or in your network’s switches, routers or
firewall) until the receiver can connect to the NOC.
To troubleshoot, you can use the PING softkey to verify your receiver can locally
connect to your network gateway.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales